Product Manuals
Manuals are listed by product model number in alphabetical order. Within a model listing, newer versions appear first. This is typically the preferred document.
If you have difficulty opening any of the PDF documents, save the document to your local drive and open the saved copy. To copy the file to your drive, right-click the link (Mac users ctrl-click) and select "save target as" or "save link as" from the popup menu.
Model ACM-1 and ACM-2
AC current monitor accessory for model RFC-1/B
Model ACU-1
Audio Control Unit
- Installation and Operation (Prophet Systems) firmware version 10
- Installation and Operation (Sine Systems) firmware version 10
Model AFS-1 through AFS-3
Audio Failsafe
- Installation and Operation model AFS-3
- Installation and Operation model AFS-2
- Installation and Operation model AFS-1
Model CAS-1
Con/Air Switcher
Model CIM-1 and CI-1
Composite audio insertion accessory for model DAI-1 and DAI-2
Model CTI-1 and CTI-2
Computer Temperature Interface
Model DAI-1 and DAI-2
Dial-up Audio Interface
- Installation and Operation model DAI-2 firmware rev 2.x and hardware rev 2
- Installation and Operation model DAI-2 firmware rev 2.x and hardware rev 1
- Operation manual model DAI-1 firmware rev 1.x
- Installation manual model DAI-1 rev 1
Model DB-1
50ms Delay board accessory for model DAI-1 and DAI-2
Model DCA-2
DC Telemetry Amplifier for model RFC-1/B
Model MA-1 and MA-2
Modem adapter accessory for model RFC-1/B
Model MBC-1 and MBC-1.5
Message Board Controller
- Installation and Operation model MBC-1.5
- Installation and Operation model MBC-1
- Documentation model MBC-1/CPx cable adapter
- Documentation model 1036 BetaBrite display (Dec 1998 and later)
- Documentation model 1024/1040 BetaBrite display (pre Dec 1998)
Model OC-2
Optocoupler accessory for model DAI-1 and DAI-2
Model PA-1 and PA-2
Printer accessory for model RFC-1/B
Model RAK-1
Intelligent Rack Adapter for model RFC-1/B
Modem and parallel port version
Model RAK-2
Intelligent Rack Adapter for model RFC-1/B
Broadband network-enabled version
Model RFC-1/B
Remote Facilities Controller
The first item is recommended. It applies to the majority of RFC-1/B systems.
- Installation and Operation model RFC-1/B firmware versions 4.x and 5.x
- Operation manual model RFC-1/B firmware version 5.x (software book)
- Operation manual model RFC-1/B firmware version 4.x (software book)
- Operation manual model RFC-1/B firmware version 3.x (software book)
- Operation manual model RFC-1/B firmware version 2.x (software book)
- Installation manual model RFC-1/B hardware version 3.x (hardware book)
- Installation manual model RFC-1/B hardware version 2.x (hardware book)
- Programming examples model RFC-1/B firmware versions 4.x and 5.x
- Programming Address Table model RFC-1/B (PDF)
- Programming Address Table model RFC-1/B (Excel spreadsheet)
Model RP-8
8-channel relay panel for model RFC-1/B
Model RS-232
Serial data accessory for model RFC-1/B
- Installation and Operation model RS-232 (9-pin D connector)
- Installation and Operation model RS-232 (25-pin D connector)
Model SIP-8
8-channel status input panel for model RFC-1/B
Model SP-8 and SP-8/TO
8-channel surge protector for model RFC-1/B
Model SU-5
Software upgrade for model RFC-1/B
- Installation manual model SU-5 (with speech upgrade module)
- Installation manual model SU-5/A (firmware only, without speech upgrade)
Model TAS-1
Telephone Announcement System
Model TS-1 and TS-1/PS
Temperature sensor accessory
Model TSN-1 through TSN-3
Thermal Sentry
- Installation and operation model TSN-3
- Installation and operation model TSN-2
- Installation and operation model TSN-1
